Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
System Initialization
3-27Administer DEFINITY ONE or IP600
3
Enable and Disable SNMP
By default, SNMP is enabled on DEFINITY ONE. If you are not using SNMP,
disable it.
To disable SNMP, enter d1disable snmp from a bash session. The command
d1disable snmp disables SNMP from being run when DEFINITY ONE is started.
To enable SNMP, enter d1enable snmp from a bash session. The command
d1enable snmp enables snmp so that it automatically runs when DEFINITY ONE
is started.
You must reboot your system for the SNMP settings to be effective.
Check customer option screen
Type system-parameters customer-options and press enter to display the
system parameters customer options screen. Ensure that the version is V10.
The license file you downloaded from RFA and installed on the switch will activate
RTU features on system parameters customer options screen. The “init” logon no
longer controls access for activating RTU (right-to-use).
Please check to ensure that the default and optional features and capacities on
the screen coincide with the customer’s order. To check the relationship between
what was ordered and what was populated on the screen please go to the RFA
information page see ‘‘Go to the RFA website’’ on page 3-15. Go to the help
information section of the RFA page, where you will find a material code/feature
job aid that details the mapping between the material codes that RFA processes
and the features, capacities, and release on the systems parameters options
screen. If there is a problem with the customer’s order, please contact the account
team so they can issue another order which will generate a corrected license file
from RFA.
To Next Page
Loading...
