Avaya DEFINITY ONE - Setting up Avaya Site Administration

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
Connectivity and Access to DEFINITY ONE or IP600
2-40System administration/Avaya Site Administration
2
Setting up Avaya Site Administration
To set up Avaya Site administration, do the following:
1. Go to the
Add System window, and choose Add Switch.
2. Assign a
name , and click Next.
3. Choose Network Connection, and click Next.
4. Enter the
IP address , and click Next.
NOTE:
The IP address is the RAS IP found in MAESTRO, or by executing
the setip command at the bash prompt.
5. Enter 22 for the
Port Number in DEFINITY, and 24 for the Port Number in
INTUITY, and click Next.
6. Set the
Timeout for establishing a connection to 60 seconds; leave the
Timeout for sustaining an idle connection at 0, and click Next.
7. Check which type of login connection to use, and click Next (If the
customer is using asg to select login manually). If manual login was
chosen, click Next.
8. If manual login was chosen, in
Switch Summary screen, click Next, do
not test
.
9. If automatic login is used, fill out the information in the next two windows.
10. When you reach the
Switch Summary screen, click Next, do not test .
11. Click Finish on the last screen.
NOTE:
The same procedure can be performed to add the INTUITY
TM
to the
Avaya Site Administration.