Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
Install and Cable the Cabinet
1-79Install DEFINITY ONE main distribution frame (MDF) and external modem
1
Install the external modem
The U.S. Robotics external modem is the recommended external modem.
DEFINITY ONE systems operate with this modem set to factory default settings.
NOTE:
You may use a locally obtained, type-approved external modem (33.6 Kbps
or higher and V.34 protocol). Contact your Avaya representative for more
information.
!
WARNING:
If you use a modem other than the U.S. Robotics modem, it must be
configured in Windows.
1. Use the hardware provided with the modem. See Figure 1-40 on page
1-78. If top-mounting MDFs, mount the external modem to the plywood in a
location which allows the standard connection to the modem cable.
2. Route the modem cable (P2) from the Processor Interface Cable through
the cable trough and to the modem.
3. Connect the cable to the modem. See Appendix A, ‘‘Cable Pinouts’’ for the
pinout of the modem cable.
4. Plug the modem power cord into an electrical outlet and turn on the
modem.
‘‘Modem configuration and administration’’ on page 9-5 describes information
about modem setup, administration, settings, and testing.
To Next Page
Loading...
