Avaya DEFINITY ONE - Rack-Mount Two Avaya IP600 Cabinets

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
Install and Cable the Cabinet
1-18Install the Avaya IP600 system cabinet
1
Rack-mount two Avaya IP600 cabinets
Mount port Cabinet B directly above processor Cabinet A.
1. Install the rectangular EMI Gasket over the right TDM/LAN bus cable
routing slot on the top of Cabinet A. Make sure open corner of the gasket
faces the rear of the cabinet. Once installed, cabinet B should rest on and
compress the gasket. See Figure 1-14 on page 1-30.
1. Follow the steps to ‘‘Rack-mount the Avaya IP600 cabinet’’ on page 1-14.
2. Proceed to ‘‘Check AC power and ground for Avaya IP600I’’ on page 1-19.