Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
Install and Cable the Cabinet
1-36Install RMC patch panels and external modem
1
Install the external modem
The U.S. Robotics external modem is the recommended external modem. Avaya
IP600 systems operate with this modem set to factory default settings.
NOTE:
You may use a locally obtained, type-approved external modem (33.6 Kbps
or higher and V.34 protocol). Contact your Avaya representative for more
information.
!
WARNING:
If you use a modem other than the U.S. Robotics modem, it must be
configured in Windows.
1. Securely mount the external modem at the left of the modem utility shelf or
another secure surface.
2. Route the modem cable (P2) from the Processor Interface Cable to the
modem and attach it to the modem port.
3. Plug the modem power cord into the same power source as the RMC(s),
preferably the UPS.
4. Connect the modem to a standard analog line using RJ45 cord.
‘‘Modem configuration and administration’’ on page 9-5 describes information
about modem setup, administration, settings, and testing.
To Next Page
Loading...
