Install and Cable the Cabinet
1-1
1
Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
Install and Cable the Cabinet
This chapter describes procedures for installing and cabling the cabinet to
physically connect and access the Avaya IP600 and the DEFINITY ONE systems.
The rack mounted cabinet (RMC) houses the Avaya IP600. The compact modular
cabinet (CMC) houses the DEFINITY ONE. This chapter also describes
procedures for installing telephones and making auxiliary connections.
NOTE:
Physical installation of both cabinets is essentially the same as for the
ProLogix cabinet. Cabling is also similar except for the processor interface
cable (multileg cable). Software, such as DEFINITY administration software,
should not be accessed until cabling and installation of the cabinet are
completed. Your configuration can consist of 1, 2, or 3 cabinets for IP600
and 1, 2, or 3 cabinets for DEFINITY ONE.
This chapter is organized as follows:
‘‘Section I - Avaya IP600 Installation’’ on page 1-3
■ ‘‘Site Requirements’’ on page 1-3
■ ‘‘Check customer’s order’’ on page 1-4
■ ‘‘Correct shipping errors’’ on page 1-4
■ ‘‘Unpack and inspect’’ on page 1-5
■ ‘‘Install the Avaya IP600 system cabinet’’ on page 1-11
■ ‘‘Check AC power and ground for Avaya IP600I’’ on page 1-19
■ ‘‘Cable the Avaya IP600 system’’ on page 1-27
■ ‘‘Install RMC patch panels and external modem’’ on page 1-34
■ ‘‘Install equipment room hardware for Avaya IP600’’ on page 1-37
■ ‘‘Set ringing option for Avaya IP600’’ on page 1-49
To Next Page
Loading...
Need help?
General
