Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
Install and Cable the Cabinet
1-2
1
‘‘Section II - DEFINITY ONE Installation’’ on page 1-51
■ ‘‘Check customer’s order’’ on page 1-51
■ ‘‘Correct shipping errors’’ on page 1-51
■ ‘‘Unpack and inspect’’ on page 1-51
■ ‘‘Install the DEFINITY ONE system cabinet’’ on page 1-56
■ ‘‘Check AC power and ground for DEFINITY ONE’’ on page 1-64
■ ‘‘Cable the DEFINITY ONE system’’ on page 1-74
■ ‘‘Install DEFINITY ONE main distribution frame (MDF) and external
modem’’ on page 1-77
■ ‘‘Install equipment room hardware for DEFINITY ONE’’ on page 1-80
■ ‘‘Set ringing option for DEFINITY ONE’’ on page 1-95
‘‘Section III - Install Telephones and Make Auxiliary Connections’’ on page 1-97
■ ‘‘Install and wire telephones and other equipment’’ on page 1-97
■ ‘‘Connect external alarms and auxiliary connections’’ on page 1-110
■ ‘‘Install the BRI terminating resistor’’ on page 1-113
■ ‘‘Install multi-point adapters’’ on page 1-117
■ ‘‘Install off-premises station wiring’’ on page 1-120
■ ‘‘Install emergency transfer panel and associated telephones’’ on page
1-125
■ ‘‘Connect modem’’ on page 1-134
■ ‘‘Connect modem to telephone network’’ on page 1-133
■ ‘‘Set neon voltage to prevent ring ping’’ on page 1-135
■ ‘‘Complete installation’’ on page 1-136
■ ‘‘View LEDs to determine power and fan alarm state’’ on page 1-136
To Next Page
Loading...
