Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
System Initialization
3-23Administer DEFINITY ONE or IP600
3
9. Click OK.
10. Double-click on the
NETWORK
icon.
The first time you use Terminal Server
TM
, you will see a challenge screen.
a. In the login box, type
skpca
.
b. The password is
pcany1
You will not be challenged again, unless your PC is rebooted.
The system now connects you, via the dial-up connection you have established,
to the system desktop. From this point, you can access the system as if you were
sitting at the console. To login, use the CAD button located on the top toolbar of
Terminal Server
TM
. After you are finished using the desktop, use the END
SESSION icon on the top toolbar. At the dial-up screen, you should still be at the
bash prompt. Close down Terminal Server
TM
by typing
terminalserver -c
, and
force the modem to disconnect by typing
rasdrop
before logging out.
Set Date and Time For IP600
Using a Laptop and the LAN
If there is no keyboard, mouse, and monitor, the customer may use the following
procedures to set the date and time on the system over their LAN.
1. Start the desktop internet browser.
2. On the browser, turn off proxies (write down your settings for restoration
later).
NOTE:
On Netscape
TM
go to Edit, Preferences, Advanced, Proxies; set to
Direct connect to Internet. On Internet Explorer
TM
4.x go to View,
Internet Options, Connection; check Connect to Internet using LAN;
uncheck Use proxy server. On Internet Explorer
TM
5.x go to Tools,
Internet Options, Connections; at the bottom of the window, click LAN
settings; uncheck Use a proxy server box, and check Automatically
detect settings; click OK until back to the web page.
3. Execute an http:// into the IP address assigned to the system.
4. Click on Administer System and login.
5. On the browser click Start java client on your computer.
a. Answer yes to the two questions asked on the agreement screens.
b. Select the IP600 on the next screen, and click Connect.
c. Login.
6. At login use the CAD icon on the top toolbar to open the login window.
To Next Page
Loading...
