Avaya DEFINITY ONE - Page 330

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
Hardware Additions
6-14Downloading Firmware to Port Circuit Packs
6
Check SPE
1. Log into DEFINITY ONE or IP600.
2. Type status system all-cabinets and press
Enter.
Locate Target Boards
If you do not know the target board locations, locate DS1 target boards, type list
configuration ds1 and press
Enter. Look for the "P" suffix in the Code column and
note the board location. You will need it later in the process. Or, To locate other
target boards, type list configuration all and press
Enter.
Verify Trunk Status (optional)
This optional procedure for DS1 target boards allows you to see which ports are in
service.
1. Type list configuration board
UUCSS and press Enter to identify the ports
associated with a particular DS1 board. Note the total number of ports.
2. Type display port
UUCSSpp , where pp is the port number of one of the
ports, and press
Enter to find the trunk group number.
3. Type status trunk
n , where n is the trunk group number, and press Enter.
Note the status of all the ports in service for that particular DS1 board.
4. If the number of ports in the group does not equal the total number of ports,
repeat step 2 for a port number not listed.
For example, if trunk group 6 shows only ports 01 through 15, then display
port 17 to identify the trunk group number for the rest of the ports for that
particular DS1 board. Note the status of all the ports in service in that trunk
group.