Avaya DEFINITY ONE - Page 333

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
Hardware Additions
6-17Downloading Firmware to Port Circuit Packs
6
■ Target Location
Make an entry for each programmable target board location, up to
50.
NOTE:
You can only download 1 image file to 1 type of target board at
a given time (for example, to all the TN464GPs). The
download process
does not support broadcasting more than 1
image file to multiple types of target boards in parallel (for
example, TN464GPs and TN2313BPs).
3. Press
Enter to submit the schedule.
NOTE:
If you set the
Schedule Download?
field to n, the download starts
as soon as you press
Enter.
Check Specified Resources
This test applies only to scheduled downloads. To check specified resources:
1. Type test firmware download and press
Enter.
2. Check for FAIL conditions.
3. If failures occur, investigate the errors by referencing FW-DWNLD
description in the appropriate maintenance book.
4. Resolve all errors.
When the test passes, all specified resources are available for the scheduled
download.
Monitor Download Progress
To monitor the progress of the download, type status firmware download and
press
Enter to view the progress of the all downloads on the schedule. The
possible flags are (P)ending, (C)ompleted, (F)ailed, or (A)borted.
Or, type status firmware download
last and press Enter to view the progress of
the previous completed download on the schedule. Also, use this command at the
end of the download schedule.
Abort a Firmware Download
If you need to abort a scheduled firmware download, type disable firmware
download and press
Enter. The software continues to download the board in
progress and then aborts the remainder of the download schedule.