Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
Troubleshooting
9-8Modem configuration and administration
9
Configure the installed modem
1. Right-click Properties.
The Properties screen displays.
2. Click OK to accept speed and speaker volume defaults.
3. Click Connection tab.
4. Click OK to accept the defaults For Data bits (8), Parity (none), Stop bits
(1), and Call Preference.
5. Click the Advanced button.
The Advanced Connection Settings screen displays.
6. Click OK to accept the defaults.
7. Click OK > Close.
The Modem Properties screen displays.
8. Click Close.
The following message displays:
Dial-up Networking requires
configuring because the list of installed modems has
changed. Would you like to do this now?
9. Click Yes.
10. The Remote Access Setup screen confirms that the modem is configured.
Test the external modem
1. At the SAT session, type change system parameters maintenance, and
Click or Submit.
2. Ensure that the Test Remote Access Port field is set to y.
3. Type test pr-maintenance and Click or Submit.
4. Verify that test 230 passes.
For more information see
DEFINITY Enterprise Communications System
Release 10 Administration for Network Connectivity
(555-233-504).
ENTER
ENTER
To Next Page
Loading...
