GAS Commands in the bash shell
G-1Avaya (Lucent) access controller bash commands
G
Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
GAS Commands in the bash shell
This chapter provides information about bash commands that are used in the
installation process. It also includes information on the setip command. These
commands are not available to the customer.
Avaya (Lucent) access controller bash
commands
The following commands are useful during installation and maintenance tasks and
are allowed for the avaya logins. After opening the LAC bash shell, enter the
name of the command. Refer to
DEFINITY ONE Maintenance
(555-233-130)
or
IP600 Maintenance
(555-600-100) for more detailed information.
Table G-1. bash commands for avaya logins
Command Description
alarmorig Turns on alarm origination from the GAM (INADS)
alarmstat Gives global alarm status (major, minor, or none) for
the GAM, DEFINITY, and Intuity AUDIX
autobackup Enables and disables backup commands
backupparams Enables day and time destination
backupsource Selects the data to be backedup
cleargamalarm Clears all GAM alarms after failure conditions are
repaired
d1backup No help
d1disable SNMP Disables SNMP
d1enable Enables SNMP
Continued on next page
To Next Page
Loading...
