Avaya IP Office Basic Edition - Page 100

Phone Based Administration Page 100
- Issue 6a (Thursday, February 22, 2018)IP Office Basic Edition
Comments on this document? infodev@avaya.com
M7324/M7324N/M7310/M7310N/T7316/T7316E Phone
1. At either of the first two extensions on the system, press Feature **config (ie. Feature **266344).
· If the system has a system password set, it is requested. Enter the password.
2. The phone displays System Admin.
3. Dial #407. The phone displays Allowed Lists.
4. At the List Number prompt, enter a list number 1 to 8.
5. At the Entry prompt, select a list entry 01 to 10.
6. Enter the first telephone number. To save the telephone number in memory, press Enter. Do one of the
following:
· To delete the telephone number you just entered, press Remove.
· To add other telephone numbers to this list, press Next Item and repeat Steps 6 and 7.
· To create another list, press Next Procedure + Prev Procedure and go to Step 5.
· To exit phone based administration at any time, press the Release button. To select a different process use the
Next Procedure or Previous Procedure buttons or dial another feature code.
ETR 18D/ETR 34D Phone
1. At either or the first two extensions on the system, press Feature 0 0 followed by two presses of the first
intercom or call appearance button.
2. System Administration: is shown on the display.
3. Dial #407. The phone displays Allowed Lists.
4. At the List Number prompt, enter a list number 1 to 8.
5. At the Entry prompt, select a list entry 01 to 10.
6. Enter the first telephone number. To save the telephone number in memory, press Enter. Do one of the
following:
· To delete the telephone number you just entered, press Remove.
· To add other telephone numbers to this list, press Next Item and repeat Steps 6 and 7.
· To create another list, press Next Procedure + Prev Procedure and go to Step 5.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then
placing it back in the cradle.
114