Avaya JEM24 Installing

Parameter name Default
value
Description
V
VLANSEPMODE 1 Specifies whether full VLAN
separation will be enabled by the
built-in Ethernet switch while the
telephone is tagging frames with a
non-zero VLAN ID. PHY2PRIO is
not supported when
VLANSEPMODE is 1.
Value operation:
• 0: Disabled
• 1: Enabled
Note:
This parameter is configured
through the settings file.
VLANTEST 60 Specifies the number of seconds
that the phone waits prior to failing
back to a different VLAN ID if no
response is received from the
DHCP server.
Valid values are 0 through 999.
A value of zero means that DHCP
tries with a non-zero VLAN ID
forever.
Note:
This parameter is configured
through:
• Settings file
• A name equal to value pair
in DHCPACK message
VOLUME_UPDATE_DELAY 2 Specifies the minimum interval, in
seconds, between backups of the
volume levels to PPM service when
the phone is registered to Avaya
Aura
®
Session Manager.
If there is no change to volume
levels, there will be no backup to
PPM service.
Valid values are 2 through 900. The
default value is 2.
Table continues…
Appendix
December 2018 Installing and Administering Avaya J100 Series IP Phones 270
Comments on this document? infodev@avaya.com

Avaya JEM24 Specifications

General

Brand	Avaya
Model	JEM24
Category	IP Phone
Language	English