Avaya JEM24 Installing

Name Description
• Registered
SIP User ID Specifies the SIP user ID used to log in to the phone.
You can also type the SIP user ID, which is a combination of the following
values:
• Upper and lower case characters.
• Numbers from 0 to 9.
• Spaces.
• Special characters. The allowed characters are the following: . , : ; “” ‘’ / ()
{} [] ` ~ * _ ! ? + - ^ # = <> | & $ —
The default value is empty.
Authentication User ID Specifies the authentication ID.
You can also type the authentication user ID in this field if authentication is
enabled on the SIP server.
The authentication user ID is a combination of the following values:
• Upper and lower case characters.
• Numbers from 0 to 9.
• Spaces.
• Special characters. The allowed characters are the following: . , : ; “” ‘’ / ()
{} [] ` ~ * _ ! ? + - ^ # = <> | & $ —
Authentication Password Specifies the authentication password.
You can also type the password in this field if authentication is enabled on
the SIP server.
Note:
The password can contain maximum 31 ASCII characters.
The default value is empty.
XSI
XSI State Specifies the status of XSI.
The values are:
• Initializing
• Success
• Failure
XSI URL Specifies the FQDN or the IP address, HTTP or HTTPS mode and the port
of the XSP server.
The valid value is a string of 0 to 255 ASCII characters.
Table continues…
Configuring the phone using web interface
December 2018 Installing and Administering Avaya J100 Series IP Phones 58
Comments on this document? infodev@avaya.com

Avaya JEM24 Specifications

General

Brand	Avaya
Model	JEM24
Category	IP Phone
Language	English