Azbil Corporation Operation using HART communicator
Model MTG11A/18A, MTG11B/18B, MTG14C 7-5
7-2 : Setting and calibrating devices using the
HART Communicator
The HART Communicator enables the user to set a two wired magnetic flowmeter
device as well as allowing them to adjust and check the output of the device and to
inspect the device. The following values can be set using the HART Communicator:
Also, the following calibrations and inspection can be made:
• Zero point adjustment
• Current output calibration at 4 mA and 20 mA
• Gain adjustment
• Pulse output adjustment
• Excitation current output adjustment
• Analog output check
• Pulse output check
• Contact output check
• Converter status check
• Tag setting
• Shipping data recovery
• Equipment information check
For a detailed list of all the menus, see the HART Communicator's menu table for the
two wired magnetic flowmeter at the back of this manual.
• Flow unit
• Range
• Specific gravity
• Damping time constant
• Display selection
• Function selection
• Correction coefficient
• Communication method
• Detector diameter
• Detector constant
• Auto spike cut
• Average processing selection
• Average processing time
• Low flow cut
• Drop out
• Pulse scale unit
• Pulse scale
• Pulse width
• Totalized value of integral counter display
• Reset value of integral counter
• Integral counter reset
• High alarm value setting
• Low alarm value setting
• Setting output status setting
• Burnout (Analog output) setting
• Burnout (Pulse output) setting
• Electrode status diagnostic function
CM2-MTG300-2001.book 5 ページ ２０１５年９月２９日 火曜日 午前１０時１４分
To Next Page
Loading...
Need help?
General
