Azbil VDC User Manual

Azbil Corporation Operation using HART communicator
Model MTG11A/18A, MTG11B/18B, MTG14C 7-13
7-2-2 : Setting converter data
Detector diameter
Follow the procedures described below to set the detector diameter.
Set the diameter size printed on the nameplate.
Detector type
Follow the procedures described below to set the detector type.
Use MTG at normal measurement.
1. From online menu,
Select:
1. Device setup
 4. Detailed setup
 1. Detector config
 1. Tube size
Figure 7-19 will then be displayed.
Figure 7-19
2. Once the display as shown in Figure 7-19 appears, move the arrow key up or
down to select a detector diameter. After making a selection, press F4
(ENTER). If F3 (ESC) is pressed here, the selection will be canceled and the
display will return to the Detector config menu.
3. After returning to the Detector config menu, press F2 (SEND). Changed
setting will be transmitted to the converter. The HART communicator mark
will appear on the upper right hand corner while HART is communicating
with the device. The mark will disappear once communication has properly
completed.
1. From online menu,
Select:
1. Device setup
 4. Detailed setup
 1. Detector config
 2. Detector type
Figure 7-20 will then be displayed.
Figure 7-20
2. Once the display as shown in Figure 7-20 appears, move the arrow key up or
down to select a detector type. After making a selection, press F4 (ENTER). If
F3 (ESC) is pressed here, the selection will be canceled and the display will
return to the Detector config menu.
3. After returning to the Detector config menu, press F2 (SEND). Changed
setting will be transmitted to the converter. The HART communicator mark
will appear on the upper right hand corner while HART is communicating
with the device. The mark will disappear once communication has properly
completed.
CM2-MTG300-2001.book 13 ページ ２０１５年９月２９日 火曜日 午前１０時１４分

Azbil VDC Specifications

General

Brand	Azbil
Model	VDC
Category	Measuring Instruments
Language	English