Thermal printer type 6761-11
134
Measuring System MAK TIGER 3003 Service manual, SA 131128, 10.03.2020
Self-test
The self-test allows you to see whether the printer is working correctly. It
checks the control circuits, print mechanism, print quality, ROM version and
DIP switch settings.
This test is independent of any other unit or software.
Running the self-test
1. Make sure that the printer is switched off and the covers are properly
closed.
2. Press and hold the FEED button and switch on the power supply to the
printer in order to start the self-test. The self-test prints out the printer
settings and then the following, cuts off the paper and waits (the PAPER
OUT LED will flash).
Self-test printout
Press the PAPER FEED button.
1. Press the FEED button to continue the printing process. The printer will
print out a sample with the character set.
2. The self-test will end automatically and the paper will be cut off after the
following line:
*** completed ***
The printer is ready to receive data as soon as the self-test has been com-
pleted.
Note:
Press the FEED button if you want to interrupt the self-test manually. Press
the FEED button again to continue the self-test.
To Next Page
Loading...
