Introduction
Tracking only occurs in BlackTrax if two or more BTSensors can see a BTBeacon at the same time.
Therefore, when placing BTSensors, there must be some overlap between what each BTSensor sees.
Place and aim BTSensors in BTWYSIWYG first before setup in the physical Space. This step is optional and
will not affect your BlackTrax project. Planning BTSensor placement in BTWYSIWYG helps you test the
BTSensor’s coverage of the venue and determine how best to position them. BTSensors must not be
placed any closer than 1m apart to help ensure optimal sensor calibration.
To Next Page
Loading...