Before Using BlackTrax
Attention: Before running the BlackTrax GUI, you must complete the following mandatory steps to
ensure a successful BlackTrax experience:
Set up the BTSystem in the Space: The BTSystem needs to be physically installed in the Space.
See BTSystem Hardware Configuration for more information.
Create a file in BTWYSIWYG: A .wyg file provides BlackTrax with information on Trackables,
Fixtures and Space dimensions. From a .wyg file, you can either generate a .btx file or send the
necessary information directly between programs. See Creating a .btx file in BTWYSIWYG for more
information.
Configure and Calibrate BTSensors using Motive: Use Motive to configure BTSensors to
inform the BTSystem on how to track and share positional information with other components.
See Calibrating a BTSensor for more information.
To Next Page
Loading...