Offset Tab
Offset tab is where you configure LED Following Settings for selecting which individual LEDs of a
BTBeacon assigned to follow a Trackable should follow.
Fixture Settings - Offset tab
LED Following Settings
Each Trackable can have the LEDs of assigned BTBeacons tracked individually by the BTSystem. This can
be used instead of the default setting which is the average position of all visible LEDs. Tracking can also
be altered, to follow a Trackable but on an offset.
To assign a fixture to an individual LED of a trackable
In the Edit Chapters widget, select the chapter the fixture is in.1.
On the Center pane, click on the Trackable the fixture is assigned to and click on the Fixture Icon of2.
the fixture to select it.
With the Fixture Icon selected, go to the Fixture Settings widget.3.
On the LED Following Settings section, click on the drop-down menu and choose the LED you4.
want to follow.
For the changes to take effect, click Apply Changes.5.
To offset the tracking of a trackable by a fixture
In the Edit Chapters widget, select the chapter the fixture is in.1.
On the Center pane, click on the Trackable the fixture is assigned to and click on the Fixture Icon of2.
the fixture to select it.
With the Fixture Icon selected, go to the Fixture Settings widget.3.
In the LED Following Settings section, select the Enable Offset checkbox to set the tracking offset4.
from the X, Y, or Z axis.
Under the Offset subsection, enter how far off from the centroid you want to offset tracking in the5.
X, Y or Z axis by entering the values in the X, Y or Z fields.
For the changes to take effect, click Apply Changes.6.
To Next Page
Loading...