Creating the Venue in BTWYSIWYG
Using the tools in BTWYSIWYG’s CAD mode, create an accurate scale representation the venue Space is
in. The suggested minimum level of detail is that it contains the floor, the walls and any pipes, trusses or
structural frames in which BTSensors or moving fixtures will be attached. The more detailed the venue,
the better looking and accurate the visualization will be.
Attention: Fixtures need to be attached to pipe or truss to be inserted. You may also insert fixtures on
the floor, but you won't be able to spin them using Fixture Properties.
Note: Due to the complexity of recreating an accurate representation of a venue, refer to the WYSIWYG
Reference Guide’s chapter on The CAD environment for a thorough understanding.
To Next Page
Loading...