In the Project Properties widget, in DMX Input section, select from the Source drop-down menu.
Result: The selected source will set the DMX input for the Chapter Control Channel of the BlackTrax
project.
To set the universe and chapter control channel
Open the Project Properties widget.1.
In the Chapter section, click on the Universe scroll box.2.
Click on Chapter Control Channel scroll box.3.
To enable the merging channel monitoring
Open the Project Properties widget.1.
In the Merging Channel section, select the Enable Monitoring checkbox to toggle.2.
Click on the Universe scroll box.3.
Click on the Channel scroll box.4.
To set the units of measurement
Open the Project Properties widget.1.
In the Display Units section, click on the drop-down menu to select Metric or Imperial.2.
Select the desired measurement type.3.
Result: The selected unit of measurement will apply to the BlackTrax project.
Attention: Inputs will always be in metric.
To Next Page
Loading...