Accuracy: Sub-millimeter
Latency: 4.2 ms
Shutter type: global
Shutter speed:
Default: 0.5 ms (500 µs)
Minimum: 0.01 ms (10 µs)
Maximum: 3.9 ms (3,900 µs) at 240 FPS
Input/Output & Power
Data: Ethernet
Synchronization: Ethernet
Power: (PoE) 8.0 watts
Sensor Status
Front Light Status
The Slim Series sensors have a front LED status light to indicate their current state in relation to the
BTServer. The following table lists the default status light colors.
Back Light Status
The Slim Series sensors also have a status indicator on the back panel and indicates the state of the
sensor only. When updating the software on your BTServer, the sensor may need a firmware update in
order to communicate to the new version. Firmware updates are automatic when starting the connection
to the BTServer. If you revert back to an older version of the firmware as well. This process is automatic.
BTSensor Functions
BTSensors are used to view BTBeacon positions in the Space. A BTBeacon's position in 3 dimensions (X,
Y, and Z) can be determined when two or more BTSensors simultaneously have a direct line-of-sight to a
connected Stringer’s LED. This information is then sent to the BTServer.
Attention:
The switch must provide consistent power to every port simultaneously in order to power each
sensor.
To Next Page
Loading...