In the Device Settings widget of a selected device, click Browse and select the firmware file and1.
load into memory.
Click Upload.2.
Result: The upload proceeds and the firmware upload process is displayed in the Status
section.
Device Manager checks if the selected device matches the firmware.3.
The firmware update begins.4.
When firmware update is complete, a checksum is performed to verify the upload.5.
When checksum is complete, the device reboots.6.
Status resets to display "Ready" if a file is loaded, or "Not Ready" if no file is loaded.7.
To program charging stations
When Device Manager opens, all devices that are connected to the Charging Station are automatically
displayed in the Device Manager widget showing the connection status and the latest applied settings.
Select a Charging Station from the list in the Charging Stations widget.1.
Result: The Charging Station Settings widget displays the identification number of the
selected Charging Station. The ID number includes the network address information.
If you added or replugged a Charging Station to the system, click Connect to check the network for2.
any Charging Station on the system.
Note: When you add a new Charging Station into the system or if the Charging Station was
unplugged from the system, you may need to enable the connection again.
If you added or replugged a Charging Station with Beacons, click Get Beacon List to poll the3.
Charging Stations and update the main list with any connected Beacons.
Note: When you add a new Charging Station into the system or if the Charging Station was
unplugged from the system, you may need to refresh the list of devices connected to the
Charging Station.
To upload firmware from charging station settings
Select a Charging Station from the Charging Stations widget.1.
Result: The Charging Station Settings widget displays the settings of the selected Charging
Station.
In the Charging Station Settings widget of the selected Charging Station, click Browse and select2.
the firmware file and load into memory.
Click Upload.3.
Device Manager checks if the firmware matches the selected device and proceeds to update.4.
To Next Page
Loading...