Technical / Programming Manual
FT128 Rev 2.2
135
17.2 EBLWin Control unit pop-up menu
Some commands might be disabled since you have to connect and log on to the control
unit to be able to select / use them.
17.2.1 Reset alarm counter
The control unit has an alarm counter that can be reset if required. (Level 2, i.e. a special
access code is required.)
17.2.2 Software version
The control unit software (S/W) version will be displayed.
17.2.3 Show event log
Three different event log lists, Alarm (500 events), Interlocking (500 events) and General
log (500 events) can be shown.
To Next Page
Loading...