Technical / Programming Manual
FT128 Rev 2.2
85
Disablement
Other
The numbering of the trigger conditions is only for "the comments to the trigger conditions"
below:
10.5.1.1 Alarm
1. Fire Alarm Zone (+Zone no.)
2. Fire Alarm Zone Address (+Zone no.+Address)
3. General Fire Alarm
4. Consecutive Fire Alarm (sequence) (+start Zone no. and address +stop Zone
no. and address + Quantity)
5. Pre Warning Zone (+Zone no.)
6. Pre Warning Zone Address (+Zone no.+Address)
7. General Pre Warning
8. Consecutive Pre Warning (+start Zone no. and address +stop Zone no. and
address + Quantity)
9. Heavy Smoke Alarm Zone (+Zone no.)
10. Heavy Smoke Alarm Zone Address (+Zone no. + Address)
11. General Heavy Smoke Alarm
12. Consecutive Heavy Smoke Alarm (sequence) (+start Zone no. and address
+stop Zone no. and address +Quantity)
13. Two Address Dependent Fire Alarm (+Zone no. +Address)
14. Two Zone Dependent Fire Alarm (+Zone no.)
15. Multiple Detector Alarm
16. One Detector Alarm
17. Key Cabinet Alarm
18. AAF Zone Alarm (+AAF Zone no.)
19. Quiet Alarm Zone (+Zone no.)
20. Quiet Alarm Zone Address (+Zone no. +Address)
21. General Fire Alarm Reset
22. Delayed Alarm Zone Address (+Zone no. +Address)
23. Delayed Alarm Zone (+Zone no.)
24. General Delayed Alarm
25. First Zone In Alarm Control Unit (+Zone no. +Control Unit no.)
26. First Zone In Alarm Zone Group (+Zone no. +Zone Group name)
27. Pre Warning Zone Group (+Zone Group name +Quantity)
28. Fire Alarm Zone Group (+Zone Group name +Quantity)
29. Heavy Smoke Alarm Zone Group (+Zone Group name +Quantity)
10.5.1.2 Interlocking
30. Interlocking Input Area Activated (+Area no.)
31. Interlocking Input Area Point Activated (+Area no. +Point)
To Next Page
Loading...