Technical / Programming Manual
FT128 Rev 2.2
18
In the display (LCD, 2x40 alphanumeric characters), the information displayed on the first
row is dependent on how many alarm points / zones having activated fire alarm (and also
convention).
On the second row, the activated alarm point / zone will be shown with an alarm text, if
programmed. For more detailed information regarding the fire alarm presentation, see the
FT128 Operation Manual.
Required Fire Brigade personnel manoeuvres are performed via the FBP in FT128.
The Control Panel (CP) is used by the FT128 owner, service personnel, etc. to
"communicate" with FT128, e.g. for commissioning, monthly tests, disablements and
maintenance. Access codes for different access levels are required. A keypad is used to
get access to the menu tree, i.e. the main and sub menus for data in / out, manoeuvres,
etc. The CP also holds several system status LEDs.
FT128 in its basic configuration is equipped with:
Oyster metal cabinet with acrylic door
Main board 4556 with:
One COM loop (0) to which the loop units are connected. For connections
and more information, see drawing F665 & F666.
Two programmable supervised voltage outputs (S0-S1). Connections and
more information, see drawing F665.
One programmable relay output (R0). Default programmed as alarm output
for routing equipment (Fire brigade TX). Connections and more information,
see drawing F665.
One non-programmable relay output (R1) for routing equipment (Fault TX).
Connections and more information, see drawing F665.
One programmable input (I0). Connections and more information, see
drawing F665.
Two 24 V
DC
power supply outputs (for routing equipment and remote display
unit). Connections and more information, see drawing F665.
A socket for an optional Communication module (RS485 transceiver
component) 4552, which will provide an RS485 interface (serial line) for up
to eight remote display units (1736 and/or 1728), see drawing F665.
RS232 interface ("D" connector) for a PC with EBLWin. Connections and
more information, see drawing F734.
RS232 interface for a Web-server 1598. Connections and more information,
see drawing F734.
24V
DC
power supply output for a Web-server 1598. Connections and more
information, see drawing F665.
Power supply and space for back-up batteries. Connections and more information,
see drawing F665.
Space for up to four optional expansion board mounted on one expansion boards
mounting kit.
Space for different brigade (ASE) interface brackets e.g. Romtec, Tyco ASE, etc.
Space for optional Web-server.
Termination board to terminate the CIE and field wiring.
Depending on the system requirements and space available, the following options
can be added to FT128:
Occupant Warning System, 60W, 120W or 250W
To Next Page
Loading...