1. Use cleaning agent (gasoline) to clean
the surface left on the vehicle body (or
windshield edge) that needs to be bonded
to the windshield. (Allow to dry for at least
10 minutes).
2. Then remove the door trim strip from
the back of the door by gripping each clip
with your fingers.
If the paint and exposed metal contact
surfaces are completely exposed, when
applying primer to the vehicle body, be
careful not to apply the primer to the
surface that retains the adhesive on the
vehicle body.
△!
Caution
The correct operation and drying time
must be carried out according to the primer
manufacturer's instructions. Do not touch
the vehicle body and old adhesive surfaces
that need to be bonded to the glass.
To Next Page