3. Install a new sealing strip onto the
glass. To facilitate installation, heat the
sealing strip at a temperature of 35°C
(95°F) for one and a half hours.
4. Wipe the glass surface of the part
bonded to the vehicle body with a clean
cloth. If cleaning with cleaning solvent,
allow to dry for at least 10 minutes.
5. Use a new brush to apply sufficient
primer around the glass surface to be
bonded to the vehicle body.
Width "b": approximately 15mm (0.59in.)
Width "c": approximately 15mm (0.59in.)
Width "d": approximately 15mm (0.59in.)
△
! Caution
The correct operation and drying
time must be carried out according to
manufacturer's instructions.
Do not apply primer on the outer
surface of the ceramic coating. Do not
touch the primer coated surface.
To Next Page