Cessna 182 1978 - Page 85

MODEL
182 & T182 SERIES
SERVICE MANUAL
CESSNA
PROGRESSIVE
CARE
MODEL
182
& T182
OPERATION
NO.
2
Registration
No.
Airplane
Model
and SN
Airplane Time
INSPECTION
COMPLETED
BY
D
9 Nose
Gear -
Inspect torque
links.
steering
rods, and
boots
for condition and
security of attachment.
Check strut for
evidence
of leakage
and proper
extension.
Check
strut
barrel for
corrosion, pitting,
and
cleanliness
Check
shimmy
damper
and.or
bungees
for
operation.
leakage,
and
attach points
for wear and security
D
10 Nose
Gear Fork
- Inspect
for cracks.
general
condition,
and
security
of
attachment.
D 12 Nose
Gear Attachment
Structure
- Inspect
for cracks.
corrosion,
or other damage
and security of attachment.
H
2 Elevator Trim
System -
Check cables.
push-pull rods.
bellcranks. pulleys,
turnbuckles. fairleads.
rub strips, etc.
for proper routing,
condition, and
security.
J
I Cowling
and Cowl Flaps
- Inspect for
cracks, dents.
and
other
damage, security
of cowl fasteners and
cowl
mounted
landing lights
for attachment.
Check
cowl flaps for
condition, security,
and operation.
J
2 Engine -
Inspect for evidence
of oil and
fuel leaks.
Wash
engine
and check
for security
of
accessories.
J 3
Engine,
Propeller
Controls.
and Linkage
- Check
general
condition, freedom
of movement through full
range Check
for proper travel.
security of attachment,
and for evidence
of
wear. Check friction
locks for proper operation.
J
4 Cowl Flap
Controls
- Check
freedom
of movement
through
full travel.
J
8 Induction
System - Check
security of
clamps, tubes,
and
ducting.
Inspect for evidence
of leakage.
J
Alternate Induction Air System
- Check for obstructions.
operation.
and
security.
J
13 Alternator. Mounting Bracket,
and Electrical Connections
-
Check condition
and security.
Check alternator belts for
condition and proper adjustment
Refer to Paragraph
16-42
for belt tension.
J 15 Oil Cooler - Check
for obstructions, leaks. and
security of
attachment
J 16 Exhaust
System - Inspect for cracks
and security.Air leak
check exhaust system.
Refer to Section
11 and 11A,
Paragraphs
11-98 and 11-75A. for inspection
procedures
J
17 Exhaust
System (turbocharged
engine)
- Inspect
couplings.
seals, clamps, and expansion
joints for cracks
Air leak
check exhaust system.
J 28
Hoses, Metal
Lines, and
Fittings - Inspect
for signs of
oil
and fuel
leaks Check
for abrasions.
chafing
secuity.
proper routing and
support and for evidence
of
deterioration
J 31 Turbocharger
(if applicable)
-
a
Inspect
turbocharger
mounting
linkage, and
attaching
parts for general
condition.
leakage
or damage
and security
of attachment
b
Check waste
gate. actuator.
controller,
oil and
vent
lines,
overboost
relief valve.
and compressor
housing
for
leakage,
apparent
damage,
security
of attachment.
and
evidence
of wear
Check
waste gate
return spring
for
condition
and
security
2-52
Revision
3