CF MOTO ZForce 950EX - Breather and Breather Idle Gear; Crankshaft Assy; Driven Gear

05-113
05 Engine
Measure bottom clearance
1
(between
inner and outer rotor) and side clearance
2
(between outer rotor and crankcase).
Replace oil pump if beyond service limit.
Bottom clearance
1
service limit: 0.25 mm
Side clearance
2
service limit: 0.25 mm
5.5.20 Breather and Breather Idle Gear
Inspect breather
1
for damage or other
defect. Replace if necessary.
Inspect breather idle gear
2
for damage
or other defect. Replace if necessary.
Inspect breather shaft
3
for damage or
other defect. Replace if necessary.
5.5.21 Driven Gear
Inspect gear teeth
1
and cylinderical
surface
3
for wear or other damage.
Inspect needle bearing
2
.
Replace driven gear if necessary.
5.5.22 Crankshaft Assy
Inspect each journal for scratches, cracks
or other damage. Replace if it does or the
crankshaft sprocket
1
breaks.
CAUTION: Replace with new parts if
the dimension is beyond service limit.
Otherwise, it will damage the engine.
1
2
1
2
3
1
2
3
1
1
057001
057002
057003
057004
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.