CF MOTO ZForce 950EX - Break-In Maintenance Checklist

CFMOTO
03-28
3.1.2 Break-In Maintenance Checklist
Perform these maintenance items at 20-hours or the distance interval, whichever arrives
rst.
Item
Break-in Maintenance
(Perform at the interval that arrives rst)
Hour Calendar Miles (km) Remarks
General lubrication 20 - 200 (320)
Lubricate all grease
points, pivots, cables, etc.
Engine oil / oil lter /
oil strainer
20 - 200 (320)
Change oil and lter.
Clean oil strainer.
► Engine air lter 20 - 200 (320)
Inspect; replace if dirty; do not
clean
■
Engine valve
clearance
20 - 200 (320)
Check and adjust as
necessary.
Front / Rear gear
case oil
20 - 200 (320)
Check level. Inspect for
leaks.
Coolant 20 - 200 (320)
Check level. Inspect for
leaks.
Transmission oil 20 - 200 (320) Inspect level.
Engine hoses,
gaskets and seals
20 - 200 (320) Inspect for leaks.
► Brake pads 20 - 200 (320) Inspect pad thickness.
Battery 20 - 200 (320)
Check terminals, clean,
test battery condition if
required.
■ Idle condition 20 - 200 (320)
Inspect for proper rpm.
See dealer for service if
out of spec or erratic.
■
Steering / Wheel
Alignment
20 - 200 (320)
Inspect steering system.
See dealer for service
if wheel alignment is
required.
►
Foot brake / Hand
brake
20 - 200 (320)
Inspect function. Adjust
as necessary.
Gear cases, CV
shafts, Propshafts
20 - 200 (320) Inspect for leaks.
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.