EasyManua.ls Logo

CF MOTO ZForce 950EX - Headlight Assy; Illumination Inspection; Light Removal and Installation

CF MOTO ZForce 950EX
312 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CFMOTO
12-14
12.6 Illumination Inspection
Turn ON ignition switch.
Turn on the headlight switch.
Inspect the headlight is on or not.
1. ON: Normal
2.OFF:
(1) Main cable open or shortcut
(2) Fuse burnt
(3) Switch damaged
(4) Relay damaged or bad contact
12.7 Light Removal and Installation
12.7.1 Headlight Assy
Headlight assy removal refers to 06
chaper.
Remove four self-tapping screws
1
.
Remove headlight
2
.
Installation
Reverse the removal procedures for
installation.
LH and RH headlight uses the same
removal&installation procedures.
1
2
1
2
3
1 DRL/position light/turn light
2 Low-beam light 3 High-beam light
120702
120701
Item Standard Standard
Fuse
Main 40A
Secondary 5A×1 10A×2 15A×4 40A×1
Light and
bulb
Headlight
30W (High-beam) 14.2W (Low-beam)
3.5W (position light) 23W (turn light)
Brake light 4.5W
Signal indicator LCD+LED
Rear license light H2 W5W bulb
Maintenance standard
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.

Table of Contents