12 Electrical System
12-11
120401
Shut down all electrical devices and engine
during removal.
Removal
Remove strip
1
.
Remove lock bolt and battery negative
cable.
Remove lock bolt and battery positive
cable.
Remove battery
2
.
12.2 Signal and Illumination System
12.2.1 Battery
CAUTION:
1. Please wear protective clothing and goggles. Keep the battery away from
sparks and open re. Only charge the battery in a well-ventilated room.
2. Do not mis-connect the positive and negative pole of battery. Remove the
negative wire rst if disassembling battery, in case it damages electrical elements.
The system of this vehicle uses negative earth mode.
3. Battery wires are not allowed to be removed while the engine is working.
4. Battery positive/negative wires and electrical control units have to be removed
before welding on the vehicle.
5. It is forbidden to puncture the wire to test the input/output electrical signals.
6. Establish the awareness of environmental protection and eective disposal of
waste generated during maintenance.
7. Keep batteries out of reach of children.
1
2
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.
To Next Page