CF MOTO ZForce 950EX - Rear Sway Bar; Rear Swing Arm

CFMOTO
09-10
9.5.2 Rear Sway Bar
Removal
Remove nut
1
.
Remove ball pin
2
.
Remove nut
3
.
Remove rear LH wheel shaft cover
4
.
Rear RH wheel shaft cover follows the
same removal procedures.
Remove rear sway bar
5
.
Installation
Reverse the removal procedures for
installation.
9.5.3 Rear Swing Arm
Removal
Remove nut
1
.
Remove bolt
2
.
Remove rear LH swing arm assy
3
.
Rear RH swing arm assy follows the same
removal procedures.
Installation
Reverse the removal procedures for
installation.
Inspection
Inspect every rod for cracks or erosion.
Replace if necessary.
Inspect swing arms for smooth movement.
Add grease through grease nozzle if
blocking or stuck.
Inspect steering knuckle for dirt or rust.
Replace if necessary.
Installation
Reverse the removal procedures for
installation.
1
2
4
3
1
2
3
5
091001
091002
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.