CF MOTO ZForce 950EX - CVT Case Cover Installation; CVT Surrounding Parts Installation

04 CVT System
04-43
1
2
2
2
2
1
1
1
1
1
Use special tool: Drive Pulley Holding
Wrench
1
to hold the drive pulley.
Install drive pulley bolt
2
(left-hand
thread).
Tighten torque: 55N•m~65N•m
Use special tool: Driven Pulley Holding
Wrench
3
to hold the driven pulley.
Install driven pulley nut
4
.
Tighten torque: 150N•m~180N•m
4.4.2 CVT Case Cover Installation
Install seal ring on CVT cover
1
.
Install CVT cover
1
.
Install cover bolts
2
.
Install cover bolts
1
.
Torque all CVT cover bolts.
Tighten torque: 7 N•m
4.4.3 CVT Surrounding Parts Installation
Rotate the sway bar
1
into position.
Install right sway bar ball pin
2
.
Secure ball pin
3
with a suitable tool, then
install nut
4
and torque to specication.
Tighten torque: 30N•m~40N•m
1
4
3
2
1
4
3
2
041304
041302
041303
041301
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.