CF MOTO ZForce 950EX - 9.3 Shock Absorber (Status 1)

CFMOTO
09-6
9.3 Shock Absorber
9.3.1 Front Shock Absorber
Removal
Remove two nuts
1
.
Remove front shock absorber
2
.
Inspection
Inspect shock absorber for cracks or
damage. Replace if necessary.
Clean the dirt on shock absorber.
Adjustment
Loosen lock nut
1
with shock absorber
wrench.
Adjust adjusting nut
2
with shock absorber
wrench.
Adjust the shock absorber according to the
load.
“S” direction is to increase the resistance.
“F” direction is to decrease the resistance.
Shock Absorber Specication:
Rebound resistance
3
(adjustable): 19±3
gear
Delivery state: 13th gear
Compression resistance (A): 18±2 gear
Delivery state: 9th gear
Compression resistance (B): 18±2 gear
Delivery state: 9th gear
Adjustment: Compression resistance is
divided into A and B. Adjust A first during
usage. If A is at the maximum gear, then it
is allowed to adjust B.
Installation
Reverse the removal procedures for
installation.
1
2
090601
A
1
2
090602
090603
090604
B
3
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.