CFMOTO
12-22
12.12.4 Engine Starting Note
Properly route according to starting
schematic diagram.
Before start engine, check if all parts are
installed correctly. EFI parts connection
refers to EFI section.
Check air intake system.
Check fuel system to ensure there is no
block or leaks. Clean if blocked to make
sure the fuel tail is OK. Reconnect the
leaking area to make sure there is no
leaking.
Measure fuel pressure with fuel pressure
gauge.
Pressure in fuel pump outlet:
330kPa±5kPa
Shift gear in Neutral.
Check EFI with PDA for fault. Eliminate the
trouble according to DTC (Diagnostic Fault
code).
Turn on ignition switch and press start
switch for (3~5)s.
After engine starts, warm up until idle
speed is stable and check it.
Idle Speed: 1300r/min±130r/min
Fuel gauge
121501
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.
To Next Page