EasyManua.ls Logo

CF MOTO ZForce 950EX - Fuel, Engine Oil, Transmission Oil and Coolant; Warranty; Engine Break-In

CF MOTO ZForce 950EX
312 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CFMOTO
01-8
1.7 Engine Break-in
There are many moving components inside the engine such as the piston, piston rings,
cylinder, crankshaft, gears, etc. During the initial use period, proper run-in for every critical
component is necessary. Break-in helps engine components match to each other and
adjust to working conditions. A new engine with careful treatment will have more e󰀩cient
performance and a longer service life.
Recommended break-in period: 20 hours or 320km (200 miles) whichever comes rst.
Operation guide:
0-10 hours or 0~160km (100 miles): Vary throttle position slowly and smoothly. Do not
operate continuously at more than 50% open throttle position. Cool down the engine for
5~10 minutes after every hour of operation. Avoid prolonged heavy acceleration.
10-20 hours or 160~320km (100 miles): Vary throttle positions slowly and smoothly. Do
not operate continuously at more than 75% open throttle position. Avoid prolonged heavy
acceleration.
CAUTION:
1. Maintain and repair as required during the break-in period.
2. After break-in, check and maintain the vehicle before normal use.
1.8 Warranty
Maintenance procedures specied in the schedule should be carried out in CFMOTO authorized
service stations. Otherwise, warranty and warranty rights may be a󰀨ected.
1.9 Fuel, Engine Oil, Transmission Oil and Coolant
Fuel: Octane US: 89 or higher unleaded gasoline. EU: E10 or 95 (RON)
Engine oil: Use of any oil other than those recommended may cause serious engine
damage. CFMOTO recommends the use of 10W-40 for 4-stroke engines. Changing
engine oil viscosity to 5W-40 due to extreme cold environments or 15W-40 due to hot
environments is acceptable. Reference the chart below for ambient temperature and
viscosity choice.
API: SJ or above engine oil.
Transmission oil: 75W-90-GL5.
Coolant: Any commercialy available 50/50 mix
antifreeze with appropriate anti-corrosion and
rust-proof properties. Freeze temperature must be lower than environment air temperature
(Typically -5 °C or lower).
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.

Table of Contents

Related product manuals