CF MOTO ZForce 950EX - 2.8 Service Tools

02-25
02 Specications/Vehicle Data
2.8 Service Tools
Measuring Tools
No. Tool name Specication Usage Remark
1 Vernier caliper 0mm~150mm Measure the length and thickness
2 Micrometer 0mm~25mm
Measure rocker arm shaft, valve rod,
camshaft’s diameter.
3 Micrometer 25mm~50mm Measure the max-range of cam
4 Micrometer 75mm~100mm Measure the piston size
5
Cylinder inner
dial gauge
Measure the cylinder diameter run out
6 Inner dial caliper 10mm~34mm
Measure rocker arm inner diameter,
cylinder pin hole, connecting rod small
hole.
7 Dial gauge 1/100 Measure the running out
8 Flatness gauge Measure the atness
9 Clearance gauge
Measure the atness and adjust the
valve clearance.
10
Plastic clearance
gauge
Measure tness clearance
11 Force gauge Measure the spring force
12 RPM gauge Measure the engine speed
13
Cylinder pressure
gauge and
connector
Measure cylinder pressure
14
Oil pressure
gauge
Measure oil pressure
15
Air pressure
gauge
Measure radiator cap open pressure
16 Ohm meter Measure the resistance
17 Ampere meter Measure the current
18 Thermo gauge Measure the temperature
19 Timing asher Test the ignition timing
20 Torque wrench In sets Measure the tighten torque
Usual and Auxiliary Tools
21 Alcohol lighter Heating up
22
Magneto gauge
stand
Install dial gauge
23 Flat plate Supplement the measuring
24 V-block Measure the running out data
25 Caliper Install valve locking block
26 Retainer caliper Install and remove the caliper
27 Caliper Install and remove the retainer
28
Impact screw
driver
Remove the screw
29 Screwdriver(-)
30 Screwdriver(+)
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.