CFMOTO
10-6
10.3 EPS
EPS (electric power steering) system
controls the motor based on the speed and
the torque of the steering wheel, providing
corresponding assistance to help the
driver complete the steering. The system
consists of a steering shaft assembly and
a controller (ECU).Because the system
adopts the speed induction type, it can
provide obvious help when the car speed is
low, and reduce the fatigue strength of the
driver.
Removal
Remove body covering parts (refer to 07
chapter).
Unplug connectors between EPS and
controller.
Remove three bolts
1
.
Remove EPS assy
2
.
Installation
Reverse the removal procedures for
installation.
EPS fuse location refers to 12 Electrical
System chapter.
NOTE: After installation, make sure of
smooth steering and same steering
angle for both sides.
Item Specication
Operating voltage range DC 10.6V~16V
Quiescent current 500mA Max
Maximum power supply
current
25A
Maximum motor current 45A
Operating temperature
range
-40°C~+85°C
Storage temperature
range
-40°C~+125°C
Motor type: Brush DC motor
Rated power 380W
Rated voltage DC12V
Rated current 40A
Rated torque 4N•m
1
2
100601
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.
To Next Page
Loading...
