CF MOTO ZForce 950EX - Drive Shaft Installation; Front Drive Shaft Installation; Rear Drive Shaft Installation

07 Powertrain
07-5
Rear Drive Shaft Inspection
1. Inspect rear drive shaft dust boots for
damage. Replace if necessary.
2. Inspect rear drive shaft middle spline
for damage or abnormal wear. Replace if
necessary.
NOTE: Inject 15g~18g grease into both
spline joints.
7.3.4 Drive Shaft Installation
7.3.4.1 Front Drive Shaft Installation
Install drive shaft
1
.
Install bolts
2
on engine side (just with
some threads, not necessary to tighten
them).
Install bolts
3
on front gear case side and
tighten them.
NOTE: Pre-tighten the bolts first, then
tighten the bolts in criss-cross way
during installation.
7.3.4.2 Rear Drive Shaft Installation
Install rear gear case assy (refer to 07
chapter).
Install clamps
1
.
NOTE: Inject 15g~18g grease into both
spline joints.
NOTE: Replace with new boots if any
defect, like cracks or damage, is found.
3
3
070501
070502
070503
1
1
1
2
1
070504
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.