CFMOTO
07-2
7.1 CV Drive Shaft
Removal
Remove wheels.
Remove shock absorbers.
Remove LH&RH steering knuckles (refer
to Chapter 09).
Pull out CV drive shaft in the horizontal
direction.
Other CV drive shafts apply the same
removal procedures.
7.2 CV Drive Shaft Service
7.2.1 CV Drive Shaft Inspection
1. Both sides of CV drive shafts should
rotate freely. Disassemble to inspect or
replace with new parts if any defect, like
being stuck, discrete rotation or noise, is
found.
2. Inspect the clearance between fixed
end dust boot universal shaft and middle
spline. Replace with new parts if the
clearance is larger than 1°30’.
3. Inspect dust boots on both sides for
damage or leakage. Replace if necessary.
4. Inspect shaft spline and limit circlip for
abnormal wear or damage. Replace if any
defect is found.
After inspection, if there is problems
with the shaft while no defect is found,
please refer to step 5. If the shaft is in
good condition, it is not necessary to
do step 5 inspection.
5. Inspect shaft cage retainer, planet
sleeve, steel balls, steel ball track and
middle shaft spline. Replace if any defect
is found.
6. Inspect shaft other parts for damage.
Replace if necessary.
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.
To Next Page