CF MOTO ZForce 950EX - 4.4 CVT Installation

CFMOTO
04-42
Install driven pulley spring
1
according to
the marks made during removal.
Install cam plate
2
onto the spring
according to the marks during removal.
The marks on sliders should be aligned
with those on cam plate.
Install shaft key
3
.
Factory Setting: B1
Use special tool: Driven Pulley
Disassembly Tool
1
to compress cam
plate.
When compressed into position, install
circlip
2
. Verify it is fully installed after
installation, then loosen the special tool.
4.4 CVT Installation
4.4.1 Drive Pulley, Driven Pulley and
Drive Belt Installation
Use special tool: Driven Pulley Fixed
Sheave and Sliding Sheave Separating
Tool
1
to separate the sheaves.
Place the drive belt
3
around the drive
pulley
2
and driven pulley
4
.
NOTE: Clean the belt thoroughly if oil
and grease is on the belt surface.
Install the driven pulley assy
1
, drive belt
2
and drive pulley assy
3
together on the
engine.
2
3
1
2
321
1
4
3
2
041202
041203
041204
041201
1
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.