CF MOTO ZForce 950EX - 5.2 Engine Removal

05-59
05 Engine
5.2 Engine Removal
5.2.1 Preliminary Work
Remove mu󰀪er (refer to Mu󰀪er section).
Remove fuel tank (refer to fuel system
section).
Remove air filter inlet pipe (refer to Air
Filter section).
Remove CVT inlet and outlet pipes (refer
to Body Covering Parts section).
Remove gearshift assy (refer Gearshift
Assy section).
Remove cab.
Disconnect injector connectors.
Disconnect ignition coils.
Disconnect water temperature connector.
Disconnect crankshaft position sensor
connector.
Disconnect speed sensor connector.
Disconnect gear sensor connector.
Disconnect O2 sensor connectors.
Disconnect T-MAP connector.
Disconnect throttle valve connector.
Remove engine ground wire.
Disconnect oil pressure sensor connector.
Disconnect high-pressure hose and fuel
vapor hose.
5.2.2 Removal
Remove bolts
1
.
Remove engine upper horizontal pipe
2
.
Coolant Drain
Open radiator cap and place a container
under engine water pump to store the
coolant.
Remove drain bolt
1
and washer to drain
the coolant until it completely drains.
1
2
1
1
051501
051502
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.