05-149
05 Engine
1
1
2
32
1
4
Install magneto rotor
1
.
Install spacer
2
.
Install bolt
3
with thread locker but not
tighten it.
Use special tool: Magneto Rotor Holding
Wrench
4
to x magneto rotor.
Tighten bolt
3
.
M12×1.25 bolt tighten torque: 70 N•m
NOTE: During installation, align the
woodruff key with the key groove on
magneto rotor.
5.6.15 MAG Crankcase Cover
Install dowel pins
1
.
Install roller needle
2
.
Install seal gasket
1
.
Install MAG crankcase cover
2
.
Install wire clips
2
.
Install bolts
1
.
2
1
1
2
2
0510501
0510502
0510503
0510504
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.
To Next Page