CF MOTO ZForce 950EX - Specifications for Service

02-15
02 Specications/Vehicle Data
Wheel/Tire
Specication
CF1000US CF1000US-A CF1000UTR-B
Front tire 29×9.00 R14 27×9.00 R14 27×9.00 R14
Rear tire 29×11.00 R14 27×11.00 R14 27×11.00 R14
Wheel bolt pattern M12×1.25-6h M12×1.25-6h M12×1.25-6h
Wheel nut pattern M12×1.25-6H M12×1.25-6H M12×1.25-6H
2.4 Specications for Service
Lubrication
Item Standard
Engine oil
capacity
Replace oil and oil lter 2500mL (2.64 qt.)
Total capacity 2600mL (2.74 qt.)
Recommended
engine oil
SAE: Use of any oil other than
those recommended may cause
serious engine damage. CFMOTO
recommends the use of 10W-40 for
4-stroke engines. Changing engine
oil viscosity to 5W-40 due to extreme
cold environments or 15W-40 due
to hot environments is acceptable.
Reference the chart below for
ambient temperature and viscosity
choice.
API level: SJ or higher.
Oil pressure
Engine RPM 1300r/min and oil temperature 90°C:
Oil pressure should be between 100kPa to 400kPa. Typical is 200kPa.
Engine RPM 6000r/min and oil temperature 90°C:
Oil pressure should be between 350kPa to 700kPa. Typical is 580kPa.
Transmission oil
Total capacity 600mL
Recommended oil SAE 75W/90 GL-5
Front gearcase
oil
Total capacity 330 mL
Recommended oil SAE 80W-90 GL-5
Rear gearcase
oil
Total capacity 400 mL
Recommended oil SAE 80W-90 GL-5
Cooling System
Item Standard
Thermostat
Open temperature 65°C ± 2°C
Full open temperature 85°C
Full open clearance Equal to or greater than 5mm at 85°C
Radiator cap opening pressure 108 kPa (1.1kgf/cm
2
)
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.