CFMOTO
05-154
Install cylinder head assy
1
.
Install bolts
2
.(Pre-tighten to 20N•m in
criss-cross pattern, and then tighten to
60N•m.)
Install bolts
3
. M6×80 bolt tighten torque:
10N•m.
NOTE: Install cylinder head assy
according to the made marks, to
prevent incorrect installation.
NOTE: Hook the timing chain during
installation, in case it falls into engine.
NOTE: Install bolts
2
first and then
bolts
1
.
Set timing sprocket
1
in timing chain.
Make the marker lines
2
on timing
sprocket parallel with cylinder head lower
surface
3
.
Install timing sprocket bolt
4
with thread
locker.
NOTE: Install timing sprockets
according to the made marks to
prevent incorrect installation.
NOTE: The marker lines
2
on timing
sprocket should be parallel with
cylinder head lower surface
3
as
picture shows.
NOTE: Do not rotate crankshaft during
installation. Inspect timing position
constantly during installation.
5.6.27 Second Cylinder Tensioner
Remove bolt
1
.
Remove washer
2
.
Put cross screw driver into hole
3
. Rotate
it clockwise to adjust tensioner arm to the
appropriate length. (Do not loosen screw driver.)
Install new seal gasket
4
.
Install timing chain tensioner
5
.
Install bolts
6
.
Loosen cross screw driver.
Install washer
2
.
Install bolt
1
.
NOTE: Install tensioners according to
the made marks to prevent incorrect
installation.
3
2
4
1
2
3
2
1
1
6
3
5
4
6
2
0511001
0511002
0511003
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.
To Next Page