12 Electrical System
12-13
1
12.3 Earth Wire Inspection
Shut down all electrical devices and engine.
Inspect earth wire
1
for normal function.
Inspect bolt
2
for looseness.
12.4 Fuse
Main fuse
1
40A (wire color: R and R/W)
EPS fuse
1
40A (wire color: R/W and R/W)
12.5 Light Maintenance Information
Pre-cautions
CAUTION:
1. Headlight is a hight watt light. The temperature is very high when it is on. Make
operation until the light totally cools down.
2. Temperature alarm switch inspection uses re source and high temperature liquid.
Do not place combustible material nearby and pay attention not to get burnt.
3. The headlight temperature will be very high when it is on. If use bear hands or
with dirty gloves to touch the bulb. It may be covered with oil dirt, which leads
to heat point, bulb deformation and damage.
4. Be careful when replacing the bulb. Do not replace the bulb when the light is
on. Turn o the ignition and wait for the bulb totally cools down. Wear clean
gloves on during replacement to avoid dirty oil on glass. Use clean cloth with
alcohol or lacquer thinner to clean the oil on bulb.
5. Check the battery performance if use the battery for inspection.
1
2
2
1
120601
120602
120603
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.
To Next Page